DTC P0601

Circuit Description

The powertrain control module (PCM) used in this vehicle utilizes an electrically erasable programmable read-only memory (EEPROM). The EEPROM contains program information and the calibrations required for powertrain diagnostics operation.

Unlike the PROM used for past applications, the EEPROM is not replaceable. When the PCM is replaced or a calibration update is required, the PCM must be programmed using approved Techline equipment.

Conditions for Running the DTC

The ignition is in the crank or the run position.

Conditions for Setting the DTC

The PCM does not contain the correct program required in order to operate the vehicle.

Action Taken When the DTC Sets

The control module illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Freeze Frame/Failure Records.

Diagnostic Aids

DTC P0601 indicates that the contents of the EEPROM have changed since the PCM was programmed. The only possible repair is PCM replacement. Remember to program the replacement PCM with the correct software and calibration for the vehicle.

Test Description

The number below refers to the step number on the diagnostic table.

The new PCM must be programmed.

DTC P0601 - PCM Memory

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check-Engine Controls?

Go to Step 2

Go to Diagnostic System Check - Engine Controls

Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement .

Did you complete the replacement?

Go to Diagnostic System Check - Engine Controls

--