Rock Valley
Stainless steel fuel tanks w/high pressure pump installed
1-800-344-1934
www.rockvalleyantiqueautoparts.com

Tube Tech
Custom made stainless steel fuel lines
479-394-646

Lokar
Throttle pedals and cables
1-865-966-2269
www.lokar.com

Keisler Automotive Engineering
Engine, Transmission Adaptors
865-609-8187
www.keislerauto.com

Charlie’s Oil Pans
Custom Aluimum Oil Pans
330-825-3586
redhemicutout.tif
S&P Street Rod Style Brackets
57hemimanifolddrawing.jpg
O2 Cool
Aluminum Radiators
812-423-0816

Street & Perfromance
Engine and accessories
479-394-5711
www.hotrodlane.cc
Artist drawing of the new and coming S&P manifold.
New Street & Performance motor mount plates.
Steel thermal coated motor mounts with rubber mounts and bolts included. Used to locate the Mopar motor mounts to a Chevy location.
57hemichevymount.jpg
New Street & Performance
5.7 HEMI to Chevy Adaptor Plates
These adaptor plates are used to relocate the 5.7 HEMI motor mounts to the Chevy motor mount location. The adaptor plates when used with the Street & Performance motor mounts allow you to set a 5.7 HEMI onto your chevy engine mounts.
challenger1030019.JPG
Because of the wide style brackets and looks we moved the battery from the drivers side radiator core support to the trunk.  Make sure battery is grounded to engine or trans, engine to frame, and engine to body.
Next step was hooking up the fuel lines to the engine.  James Miller with Tube Tech runs a stainless fuel line system with hard lines and braided hoses.
challenger1030020.JPG
S& P polished the radiator that was from “O-2 Cool” and the electric fan schroud.  Note that on the side of the throttle body is the motor for the drive by wire system.  We connected the electric fan to a thermostat control switch that incorporates an over-ride to activate the fan when the a/c is turned on.
P1010002.JPG
Bleeding the master cylinder for the hydrolic clutch on the tremec 5-speed.
Darrenna012.JPG
Oxygen sensor is put in the exhaust as close to the engine as possible.  Which uses a heated O2 so that it will go into closed loop system quicker.  
Darrenna010.JPG
For the exhaust system we had Stacy Nash of Mena Oil and Tire to bend the new pipe and install the Flow Master mufflers. The exhaust system was then removed and coated inside and out by S&P.
challenger1030016.JPG
hemimounts.jpg